Fant 10007 publikasjoner. Viser side 83 av 401:
Atmospheric inversions have been used for the past two decades to derive large-scale constraints on the sources and sinks of CO2 into the atmosphere. The development of dense in situ surface observation networks, such as ICOS in Europe, enables in theory inversions at a resolution close to the country scale in Europe. This has led to the development of many regional inversion systems capable of assimilating these high-resolution data, in Europe and elsewhere. The EUROCOM (European atmospheric transport inversion comparison) project is a collaboration between seven European research institutes, which aims at producing a collective assessment of the net carbon flux between the terrestrial ecosystems and the atmosphere in Europe for the period 2006–2015. It aims in particular at investigating the capacity of the inversions to deliver consistent flux estimates from the country scale up to the continental scale.
The project participants were provided with a common database of in situ-observed CO2 concentrations (including the observation sites that are now part of the ICOS network) and were tasked with providing their best estimate of the net terrestrial carbon flux for that period, and for a large domain covering the entire European Union. The inversion systems differ by the transport model, the inversion approach, and the choice of observation and prior constraints, enabling us to widely explore the space of uncertainties.
This paper describes the intercomparison protocol and the participating systems, and it presents the first results from a reference set of inversions, at the continental scale and in four large regions. At the continental scale, the regional inversions support the assumption that European ecosystems are a relatively small sink (−0.21±0.2
Pg C yr−1). We find that the convergence of the regional inversions at this scale is not better than that obtained in state-of-the-art global inversions. However, more robust results are obtained for sub-regions within Europe, and in these areas with dense observational coverage, the objective of delivering robust country-scale flux estimates appears achievable in the near future.
2020
Global occurrence, chemical properties, and ecological impacts of e-wastes (IUPAC Technical Report)
The waste stream of obsolete electronic equipment grows exponentially, creating a worldwide pollution and resource problem. Electrical and electronic waste (e-waste) comprises a heterogeneous mix of glass, plastics (including flame retardants and other additives), metals (including rare Earth elements), and metalloids. The e-waste issue is complex and multi-faceted. In examining the different aspects of e-waste, informal recycling in developing countries has been identified as a primary concern, due to widespread illegal shipments; weak environmental, as well as health and safety, regulations; lack of technology; and inadequate waste treatment structure. For example, Nigeria, Ghana, India, Pakistan, and China have all been identified as hotspots for the disposal of e-waste. This article presents a critical examination on the chemical nature of e-waste and the resulting environmental impacts on, for example, microbial biodiversity, flora, and fauna in e-waste recycling sites around the world. It highlights the different types of risk assessment approaches required when evaluating the ecological impact of e-waste. Additionally, it presents examples of chemistry playing a role in potential solutions. The information presented here will be informative to relevant stakeholders seeking to devise integrated management strategies to tackle this global environmental concern.
2020
The main goal for the “Towards better exploitation of Satellite data for monitoring Air Quality in Norway using
downscaling techniques” (Sat4AQN) project was to evaluate the potential of spatially downscaling satellite data using a
high-resolution Chemical Transport Model (CTM) to spatial scales that are more relevant for monitoring air quality in
urban areas and regional background sites in Norway. For this demonstration project, we focused on satellite aerosol
optical density (AOD) and particulate matter (PM) estimates.
NILU
2020
The current report provides a short overview of previous years’ studies on long-term trends in O3, NO2 and PM and the role of meteorological variability for the concentration of these pollutants. The previous studies on the link between trends and meteorology has shown that these links could be estimated by a careful design of model setups using CTMs (chemical transport models). The conclusions from this work is that CTMs are certainly useful tools for explaining pollutant trends in terms of the separate impact of individual physio-chemical drivers such as emissions and meteorology although computationally demanding. The statistical GAM model that have been developed as part of the recent ETC/ACM and ETC/ATNI tasks could be considered as complementary to the use of CTMs for separating the influence of meteorological variability from other processes. The main limitation of the statistical model is that it contains no parameterisation of the real physio-chemical processes and secondly, that it relies on a local assumption, i.e. that the observed daily concentrations could be estimated based on the local meteorological data. We found clear differences in model performance both with respect to geographical area and atmospheric species. In general, the best performance was found for O3 (although not for peak levels) with gradually lower performance for NO2, PM10 and PM2.5 in that order. With respect to area, the model produced the best predictions for Central Europe (Germany, Netherlands, Belgium, France, Austria, Czech Republic) and poorer agreement with observations in southern Europe. Although the GAM model did not detect many meteorology induced long-term trends in the data, the model is well suited for separating the influence of meteorology from the other driving forces, such as emissions and boundary conditions. The GAM model thus provides robust and smooth long-term trend functions corrected for meteorology as well as the perturbations from year to year, reflecting the variability in weather conditions. One could consider to define a set of performance criteria to decide if the GAM model is applicable for a specific station and parameter.
ETC/ATNI
2020
VANDAM Final Report. June 2020.
The current document summaries the work carried out in the PRODEX project NILU VANDAM: PEA: 4000118977.
NILU
2020
Solar irradiance has been universally acknowledged to be dominant by quasi-decadal variability, which has been adopted frequently to investigate its effect on climate decadal variability. As one major terrestrial energy source, solar-wind energy flux into Earth's magnetosphere (Ein) exhibits dramatic interannual variation, the effect of which on Earth's climate, however, has not drawn much attention. Based on the Ein estimated by 3D magnetohydrodynamic simulations, we demonstrate a novelty that the annual mean Ein can explain up to 25% total interannual variance of the northern-hemispheric temperature in the subsequent boreal winter. The concurrent anomalous atmospheric circulation resembles the positive phase of Arctic Oscillation/North Atlantic Oscillation. The warm anomalies in the tropic stratopause and tropopause induced by increased solar-wind–magnetosphere energy persist into the subsequent winter. Due to the dominant change in the polar vortex and mid-latitude westerly in boreal winter, a ‘top-down’ propagation of the stationary planetary wave emerges in the Northern Hemisphere and further influences the atmospheric circulation and climate.
2020
Polycyclic aromatic hydrocarbons (PAHs) are not
declining in Arctic air despite reductions in their global emissions.
In Svalbard, the Longyearbyen coal-fired power plant
is considered to be one of the major local sources of PAHs.
Power plant stack emissions and ambient air samples, collected
simultaneously at 1 km (UNIS) and 6 km (Adventdalen)
transect distance, were analysed (gaseous and particulate
phases separately) for 22 nitro-PAHs, 8 oxy-PAHs,
and 16 parent PAHs by gas chromatography in combination
with single quadrupole electron capture negative ionization
mass spectrometry (GC-ECNI-MS) and gas chromatography
in combination with triple quadrupole electron ionization
mass spectrometry (GC-EI-MS/MS). Results confirm low
levels of PAH emissions (Sum 16 PAHs D 1:5 μg/kg coal)
from the power plant. Phenanthrene, 9,10-anthraquinone, 9-
fluorenone, fluorene, fluoranthene, and pyrene accounted for
85% of the plant emission (not including naphthalene). A dilution
effect was observed for the transect ambient air samples:
1.26+/- 0.16 and 0.63+/- 0.14 ng/m3 were the sum of all
47 PAH derivatives for UNIS and Adventdalen, respectively.
The PAH profile was homogeneous for these recipient stations
with phenanthrene and 9-fluorenone being most abundant.
Multivariate statistical analysis confirmed coal combustion
and vehicle and marine traffic as the predominant
sources of PAHs. Secondary atmospheric formation of 9-
nitroanthracene and 2C3-nitrofluoranthene was evaluated
and concluded. PAHs partitioning between gaseous and particulate
phases showed a strong dependence on ambient temperatures
and humidity. The present study contributes important
data which can be utilized to eliminate uncertainties in
model predictions that aim to assess the extent and impacts
of Arctic atmospheric contaminants.
2020
Estimates of past emission inventories suggest that toxic heavy metal pollution in Europe was highest in the mid‐1970s for lead and in the mid‐1960s for cadmium, but these previous estimates have not been compared to observations. Here, alpine ice‐cores were used to document cadmium and lead pollution in western Europe between 1890 and 2000. The ice‐core trends show that while lead pollution largely from leaded gasoline reached a maximum in ~1975 as expected, cadmium pollution primarily from zinc smelters peaked in the early‐1980s rather than in ~1965 and was up to fourfold higher than estimated after 1975. Comparisons between ice‐core trends, estimated past emissions, and state‐of‐the‐art atmospheric aerosol transport and deposition modeling suggest that the estimated decreases in cadmium emissions after 1970 were based on overly optimistic emissions reductions from the introduction of pollution control devices and other technological improvements.
2020
Health Risk Assessment of Air Pollution in Europe. Methodology description and 2017 results
This report describes the methodology applied to assess health risks across Europe in 2016, published in the European Environmental Agency’s Air Quality in Europe – 2019 report. The methodology applied is based on the work by de Leeuw and Horálek (2016), with a few adjustments. To estimate the health risk related to air pollution, the number of premature deaths and years of life lost related to exposure to fine particulate matter, ozone and nitrogen dioxide exposure were calculated for 41 countries across Europe. The results show that the largest health risks are estimated for the countries with the largest populations. However, in relative terms, when considering e.g., years of life lost per 100 000 inhabitants, the largest relative risks are observed in central and eastern European countries, and the lowest are found for the northern and north-western parts of Europe. Additionally to the assessment, a sensitivity analysis was undertaken to comprehend how much the presumed baseline concentration levels, the concentration below which no health effects are expected, affect the estimations. In addition, a benefit analysis, assuming attainment of the PM2.5 WHO guidelines across Europe, shows a reduction over 30 % of the 2017 premature deaths and years of life lost numbers.
ETC/ATNI
2020
We present an observing simulated system experiment (OSSE) dedicated to evaluate the potential added value from the Sentinel-4 and the Sentinel-5P observations on tropospheric ozone composition. For this purpose, the ozone data of Sentinel-4 (Ultraviolet Visible Near-infrared) and Sentinel-5P (TROPOspheric Monitoring Instrument) on board a geostationary (GEO) and a low-Earth-orbit (LEO) platform, respectively, have been simulated using the DISAMAR inversion package for the summer 2003. To ensure the robustness of the results, the OSSE has been configured with conservative assumptions. We simulate the reality by combining two chemistry transport models (CTMs): the LOng Term Ozone Simulation - EURopean Operational Smog (LOTOS-EUROS) and the Transport Model version 5 (TM5). The assimilation system is based on a different CTM, the MOdele de Chimie Atmospherique a Grande Echelle (MOCAGE), combined with the 3-D variational technique. The background error covariance matrix does not evolve in time and its variance is proportional to the field values. The simulated data are formed of six eigenvectors to minimize the size of the dataset by removing the noise-dominated part of the observations. The results show that the satellite data clearly bring direct added value around 200 hPa for the whole assimilation period and for the whole European domain, while a likely indirect added value is identified but not for the whole period and domain at 500 hPa, and to a lower extent at 700 hPa. In addition, the ozone added value from Sentinel-5P (LEO) appears close to that from Sentinel-4 (GEO) in the free troposphere (200-500 hPa) in our OSSE. The outcome of our study is a result of the OSSE design and the choice within each of the components of the system.
2020
A schematic sampling protocol for contaminant monitoring in raptors
Birds of prey, owls and falcons are widely used as sentinel species in raptor biomonitoring programmes. A major current challenge is to facilitate large-scale biomonitoring by coordinating contaminant monitoring activities and by building capacity across countries. This requires sharing, dissemination and adoption of best practices addressed by the Networking Programme Research and Monitoring for and with Raptors in Europe (EURAPMON) and now being advanced by the ongoing international COST Action European Raptor Biomonitoring Facility. The present perspective introduces a schematic sampling protocol for contaminant monitoring in raptors. We provide guidance on sample collection with a view to increasing sampling capacity across countries, ensuring appropriate quality of samples and facilitating harmonization of procedures to maximize the reliability, comparability and interoperability of data. The here presented protocol can be used by professionals and volunteers as a standard guide to ensure harmonised sampling methods for contaminant monitoring in raptors.
2020